User guide

35
Installing the Access Point
Step 1: Preconfigure the Access Point
Figure 19. Sample configuration in the Internet Protocol (TCP/IP) Properties
dialog box
2. Connect the Access Point to the Administrative
Computer
1. Connect one end of an Ethernet cable to an Ethernet port on the Access Point,
and then connect the other end to the administrative computer’s Ethernet port.
2. Take out the supplied power adapter from the AP package, connect the power
jack to the AC connector on the rear panel of the AP, and then plug in the adapter
to a power source. After a minute, the power LED on the AP turns solid green.
You have completed connecting the AP to the administrative computer.
3. Log Into the Access Point’s Web Interface
1. On the administrative computer, open a Web browser window.
2. In the address or location bar, type the following address:
https://192.168.0.1
3. Press <Enter> on the keyboard to connect to the Access Point’s Web interface.
A security alert message appears.
4. Click Yes or OK (depending on the browser) to continue. The Access Point’s login
page appears.