User guide

Configuring Wireless Settings
Configuring Wireless # Settings
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 87
Rate Limiting This button opens a page where you can configure upload and
download limits per station. For more information, see
“Rate
Limiting” on page 97
.
Access Control This button opens a page where you can configure access controls
for the WLAN. For more information, see
“Controlling Access to the
Wireless Network” on page 97
.
Packet Forward
Isolated: Selecting Isolated causes the traffic from this WLAN to
terminate at the Access Point.
Bridge to WAN: The default setting, Bridge to WAN forwards
packets arriving on this WLAN to the WAN (uplink) port and eventually
to their external destinations using Layer 2 forwarding.
Local Subnet NAT and Route to WAN: This setting allows routing
of wireless packets to their destinations using Layer 3 network
address translation (NAT).
Bridge to L2TP Tunnel: Uses Layer 2 Tunneling Protocol to deliver
packets encapsulated with an L2TP header in UDP datagrams.
Hotspot Service Select a Hotspot configuration from the list to enable Hotspot service
on this WLAN, after you have configured it from the
Configuration >
Hotspot
page. Refer to “Configuring Hotspot Service” on
page 106
.
Local Subnet This option appears if you have selected Local Subnet NAT and Route
to WAN under Packet Forwarding, and allows you to choose which
subnet this WLAN’s traffic is part of. You must have previously
configured a subnet from the Configuration > Local Subnets page
before it becomes available here.
Access VLAN Enter a VLAN ID to segment all traffic arriving from this WLAN to a
specified VLAN. Default is 1.
Dynamic VLAN This setting is available only with WPA encryption and 802.1X
authentication. Dynamic VLAN allows the dynamic assignment of
VLANs to clients based on RADIUS attributes. Enable this option only
if your RADIUS server is configured to segment clients using dynamic
VLAN.
Table 26. WLAN options (Continued)