User guide

Configuring Internet Settings
Obtaining and Assigning an IP Address
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 73
Figure 30. Renew or Release DHCP
2 Review the current settings.
3 If the current Connection Type is dhcp, then you are able to see the currently-
assigned IP address and subnet mask listed below.
• To force the AP to release its DHCP-assigned IP address, click Release
DHCP. This disconnects the user from Web interface as the system reverts
to its default IP address. Log in to the device using the default IP address
(
192.168.0.1 (or 192.168.100.2 for Cable Modem APs) and click Renew
DHCP to request a new lease from the DHCP server.
• Click Renew DHCP to request a new IP address lease from the DHCP server.
Note: The IP address may or may not change depending on the lease time
offered to this device.
4 Click Update Settings to save your changes.
Configuring IPv4 Auto or Manual Configuration
If you leave the Access Point at its default configuration, it attempts to obtain an
IPv4 address from a DHCP server on the network.
1 Go to Configuration > Internet.
2 In IPv4 Connection Type, select DHCP.
3 In IPv4 DNS Mode, select Auto or Manual.
• When you select Auto, the AP automatically searches for an IPv4 DNS server.
• When you select Manual, also make the following entries: