User guide

Configuring Device Settings
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 69
•In Temperature Update (specific models only), enter the interval (in seconds)
to report the internal temperature of the device.
4 Under Service Provider Login, change the login information as required:
• Username: Type the name that you want to use for logging into the Web
interface. The default user name is super.
• Current Password: When you are changing the password, enter the existing
password here.
• New Password: When you are changing the password, enter the new
password The default password is sp-admin. The password must consist
of six to 32 alphanumeric characters only.
• Confirm New Password: Retype the new password to confirm.
5 Under Login remote authentication, click the TACACS+ State box to enable the
TACACS+ server interface, if required.
NOTE Terminal Access Controller Access-Control System Plus (TACACS+) is an
AAA protocol used to authenticate administrator login to this device. Users can be
authenticated/authorized to monitor, operate or configure this device. Default is
disabled. Administrators can be assigned any of the following three administration
privilege levels:
• Super Admin (Perform all configuration and management tasks)
• Operator Admin (Change settings affecting single APs only)
• Monitoring Admin (Monitoring and viewing operation status only)
If the TACACS+ server state is enabled, then configure the TACACS+ server
parameters:
• TACACS+ server: IPv4 or IPv6 server address.
• TACACS+ port: 49 is the default, but it can be set to any available TCP port.
• TACACS+ Service: Login name.
• Share Key: TACACS+ Password.
• Confirm Share Key: retype the TACACS+ Password.
6 Click Update Settings to save and apply your changes.