User guide

Getting to Know the Access Point Features

SmartCell SC8800-S Outdoor Access Point

ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 51

Figure 21 identifies the AP bottom-panel connectors and LED locations on the AP.

Tab l e 18 describes these connectors and LEDs.

Figure 21. Bottom-panel connectors and LED locations

Table 18. Bottom-panel connectors

No. Label Description

Earth

ground

screw

Use this screw to attach an earth ground to the AP as required by

local regulations.

power

connector

You can use AC to supply power to the AP, in addition to using PoE.

PoE OUT

RJ45 data

connector

Supports 10/100/1000Mbps connections and PoE out. If the AP is

powered using AC or the Ruckus Wireless PoE injector (ordered

separately), then this port can supply 802.3af (15.4W) PoE to a

connected PoE-capable device (for example, an IP-based

surveillance camera). This port alternatively can supply 802.3at

(25.5W) PoE when used with 20m (65.6 ft.) or shorter CAT5e UTP

or better cable.

RESET

button

This button resets the AP to its factory defaults, and is mounted

under the

RESET/PoE OUT RJ-45 waterproof gland.

PoE IN

RJ45 data

connector

Supports 10/100/1000Mbps connections, connects to the

network and receives Power over Ethernet (PoE) from the Ruckus

Wireless 60W PoE injector.

1 2 3

5 6