User guide

Getting to Know the Access Point Features
SmartCell SC8800-S Outdoor Access Point
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 50
SmartCell SC8800-S Outdoor Access Point
CAUTION! SmartCell SC8800-S requires a minimum of ZoneFlex (ZF) firmware
version 9.6.1 and later to operate. DO NOT CONNECT THE SC8800-S TO A
RUCKUS WIRELESS CONTROLLER WITH ZF 9.6.0 OR EARLIER.
Figure 20 identifies the top-panel connectors on the AP. Ta b le 17 describes these
connectors.
Figure 20. Top-panel connectors
Table 17. Top-panel connectors
No. Label Description
1
5GHz
ANT 0
port
5GHz 50-ohm N-type connector. Can be used with an external
antenna for operator-defined coverage areas and point-to-point
deployments.
2
2.4 GHz
ANT 2
port
2.4GHz 50-ohm N-type connector. Can be used with an external
antenna for operator-defined coverage areas and point-to-point
deployments.
3
2.4 GHz
ANT 0
port
2.4GHz 50-ohm N-type connector. Can be used with an external
antenna for operator-defined coverage areas and point-to-point
deployments.
4
5GHz
ANT 2
port
5GHz 50-ohm N-type connector. Can be used with an external
antenna for operator-defined coverage areas and point-to-point
deployments.
1
23
4