User guide

Getting to Know the Access Point Features
ZoneFlex 7762-AC Access Point
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 23
Status LED If the AP is operating in standalone mode:
•
Amber: The WLAN service is up and at least one wireless client is
associated with the AP.
•
Flashing amber: The WLAN service is up and no wireless clients
are currently associated with the AP.
If the AP is being managed by Ruckus Wireless ZoneDirector:
• Green: The AP is part of a mesh network (either as Root AP or
Mesh AP) and is connected to an uplink with good signal. If
mesh networking is disabled but the WLAN service is available,
the Status LED is also green.
• Fast flashing green: The AP is part of a mesh network (as Mesh
AP) and is connected to an uplink with fair signal.
• Slow flashing green: This Mesh AP is searching for an uplink or
is attempting to establish communication with ZoneDirector.
• Off: Mesh networking is disabled and the WLAN service is
unavailable.
RJ45
Connectors
Two LAN ports that support Power over Ethernet (PoE):
•
PoE IN port: Supports 10/100/1000Mbps connections, connects
to the network and receives 802.at PoE from the Ruckus Wireless
60W PoE injector (not supplied, may be ordered separately – part
number 902-0180-XX00, where XX is the country code).
•
PoE OUT port: Supports 10/100Mbps connections. If the AP is
using AC power or the Ruckus Wireless PoE injector (ordered
separately), this port can supply 802.3af PoE to the connected
PoE-capable device (for example, a 3G/4G small cell radio or an
IP-based surveillance camera).
To use this port to supply PoE, you first need to enable the PoE
feature on the Web interface. If you use PoE only to power the AP
and you want to use the PoE OUT port to supply power to another
device, you must use the Ruckus Wireless 60W PoE injector (part
number 902-0180-XX00, where XX is the country code), which
may be ordered separately.
AC Power
Connector
You can use AC to supply power to the AP, in addition to using PoE.
Table 6. LEDs and connectors on the 7762-AC AP (Continued)
Label Description