User guide

Enabling Other Management Access Options
Pointing the AP to FlexMaster
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 125
Pointing the AP to FlexMaster
Your ZoneFlex device is required to “call home” to register with your FlexMaster;
FlexMaster does not initiate initial contact. To register successfully with FlexMaster,
your ZoneFlex device must know the FlexMaster server’s URL. You need TCP ports
80 and 443 open between APs and FlexMaster when traversing Layer 3/firewall
boundaries.
1 Go to Administration > Management.
2 Under TR-069/SNMP Management Choice, click Auto.
3 In FlexMaster Server URL, type the URL of the FlexMaster server.
4 Tog g l e t h e Periodic FlexMaster Inform Interval drop-down list to select how
frequently the device checks the FlexMaster server for any pending configuration
changes available for that ZoneFlex unit. On the FlexMaster side, this field is
referred to as the Periodic Inform Interval.
5 Click Update Settings to save your changes.
After the AP registers with FlexMaster, this Administration > Management page
shows the communication status between the AP and FlexMaster.
Current Time Shows the current date and time as known to the AP. This
timestamp is accurate if an NTP server is configured on the AP.
If there is no NTP server configured, this timestamp is useful as
a reference for comparison of the timestamps for
Last
attempted contact
and Last successful contact.
Table 39. TR-069 status information (Continued)
Status Information Description