User guide

Enabling Other Management Access Options
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 122
2 Review the access options listed in Ta b l e 37 , and then make changes as needed.
Table 37. Management Access Options
Option Description
Telnet Access By default, this option is disabled (inactive).
Telnet Port This field lists the default Telnet port of 23 — only if Telnet is active.
You can manually change this port number, if required.
SSH Access By default, this option is enabled (active).
SSH Port This field lists the default SSH port of 22—only if SSH is active.
You can manually change this port number if required.
HTTP Access This option is disabled by default.
HTTP Port This field lists the default HTTP port of 80, if HTTP has been
activated. You can manually change this port number if required.
HTTPS Access By default this option is enabled. This connection mode requires
a security certificate, a copy of which has been pre-installed in the
device.
HTTPS Port This field lists the default HTTPS port of 443—only if HTTPS has
been activated. You can manually change this port number if
required.
Certificate
Verification
This notes whether the security certificate linked to the HTTPS
settings has been verified (
PASSED) or not.
Auto-provisioning This setting is disabled by default, and should only be enabled if
using a FlexMaster server for AP management.
Start Recovery SSID
after ___ seconds of
connectivity loss
When connectivity is lost for this time, the recovery process is
invoked. Default is 300 seconds. Enter 0 to disable this function.
Only available on selected APs.
Continue service
WLANs when in
recovery mode
When the recovery process is invoked, the WLAN service is
continued (
Enabled) or halted (Disabled). Only available on
selected APs.