User guide

Viewing Current Wireless Settings
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 118
If you want to make changes to any of these settings, go to the Configuration >
Wireless/Radio 2.4G/Radio 5G page. Refer to “Configuring Common Wireless
Settings” on page 80 for more information.
Channel Shows the wireless channel that the AP is currently using. If you
set the wireless channel to
SmartSelect, this field shows the
value
Channel # [SmartSelect].
Channel Width 11n devices only. Displays whether the channel width is set to
20MHz or 40MHz.
Country Code Shows the country code that the AP has been set to use.
CAUTION: Verify that the AP is using the correct country code
to make sure it uses only the allowed radio channels in your
region. Selecting the incorrect country code may result in
violation of applicable laws.
AeroScout RFID tag
detection
Shows Enabled if you enabled AeroScout RFID tag detection.
The default setting is
Disabled.
AeroScout Engine
communication
daemon
Shows
Up if the communication agent on the AP is able to relay
location data from AeroScout Tags to the AeroScout Engine.
If the communication agent is unable to relay data or AeroScout
tag detection is disabled, this field shows
Down.
Ekahau Engine
communication
daemon
Shows
Enabled if you enabled Ekahau RFID tag detection. The
default setting is
Disabled.
ERC IP Ekahau Real Time Location System RTLS Controller IP address.
ERC Port TCP port used by the Ekahau Real Time Location System RTLS
Controller.
Table 36. Common Wireless settings (Continued)