User guide

Configuring Ethernet Ports
Configuring Wireless # Settings
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B 102
3 Review the following table and make changes as needed for all of the Ethernet
ports.
VLAN • UNTAG ID: Enter a valid VLAN ID in this field to segment
traffic arriving on this port to a specific VLAN. Default is 1.
Valid VLAN entries are 1-4094.
•
Members: Displays the VLAN membership of the port.
(Membership is configurable only for the
General port type.)
•
Guest VLAN: Enter the guest VLAN, from 1 to 4094.
•
Enable Dynamic VLAN: Enable dynamic VLAN only with
802.1X authentication. Dynamic VLAN allows the dynamic
assignment of VLANs to clients based on RADIUS
attributes. Enable this option only if your RADIUS server is
configured to segment clients using dynamic VLAN.
Refer to
“Working with Port-Based VLANs” on page 104
for more information.
Insert DHCP Option 82 When this option is enabled for an Ethernet port, additional
information is encapsulated in DHCP option 82 and inserted
into DHCP request packets.
The current format of option 82 is:
Circuit ID sub-option:
ETH:<IFNAME>:<VLAN>:N/A:
<MODEL>:<HOSTNAME>:<DEVMAC>
This option supports the ability for a service provider to
allocate IP addresses intelligently by considering information
on the origin of the IP allocation request.
Client Fingerprinting When this option is enabled the AP attempts to identify client
devices by their operating system, device type and host name,
if available.
Table 31. All Ethernet port options
Setting Description
Authentication Server
(required)
Enter the authentication server IP address, port, and server
secret for all Ethernet ports. Only available if 802.1X
Authenticator are enabled (includes any packet forward
selection).
Table 30. Individual Ethernet port options (Continued)