Installation guide

70
Appendix B: Resetting the Access Point to Factory Default Settings
Appendix B: Resetting the Access Point to
Factory Default Settings
You can reset the AP to its factory default settings by pressing the reset button that is
located next to the RJ-45 PoE OUT port.
1. Use a 27mm socket to remove the middle RJ-45 PoE OUT cable gland.
2. Make sure that the AP is powered.
3. Locate the reset button next to the RJ-45 port.
4. Using a pen or a similar pointed object, press the button for 10 seconds.
5. Verify that the STATUS LED on the AP is off. If the STATUS LED is off, it indicates that
the reset process is complete.
You have completed resetting the AP to its factory default settings.
Figure 37. Location of the reset button
Reset button