Installation guide

63
Installing the 7782 Access Point in the Field
Verifying Access Point Operation
Associating a Wireless Client with the AP
1. In the client device's wireless interface, select the SSID configured in the “Configuring
Wireless # Settings” on page 26 section.
2. Connect the client device to the selected WLAN SSID.
After the wireless client successfully connects to the wireless LAN, continue with Checking
the TR069 Status (FlexMaster Management Only).
Checking the TR069 Status (FlexMaster Management
Only)
If you configured the AP to report to a FlexMaster server on the network, then make sure
you verify that it can successfully communicate with the FlexMaster server. You can do this
by checking the TR069 status on the AP’s Web interface.
1. Log in to the AP’s Web interface as described in “
Logging In to the Access Point’s Web
Interface” on page 22.
2. Go to the Administration > Management page.
3. Scroll down to the TR069 Status section.
4. Check the value for Last successful contact. If it shows a date in green, this indicates
that the AP was able to communicate successfully with FlexMaster.
You have completed installing the 7782 AP in the field. Continue with What to Do Next
.