Installation guide

Installing the 7782 Access Point in the Field

Mounting the Access Point

2. Insert an M8 hex bolt into the vertical screw hole on the mounting bracket.

3. Finger tighten the hex bolt until it passes through the screw hole on the hanger mount.

4. Adjust the orientation of the AP as required.

NOTE: If the GPS feature is to be used on this AP, then make sure that the GPS antenna

is mounted outdoors and pointed up or toward a mostly-unobstructed view of the sky as

described in “

Positioning the GPS Antenna” on page 9.

5. Using a 13mm wrench, tighten the M8 hex bolt until the mounting bracket is securely

fastened to the hanger mount.

Dome-Down Mounting

NOTE: If this installation is to have external 2.4GHz, 5GHz or GPS antennas attached to

the 7782-E AP, mount the AP with the external antenna connectors facing up or sideways

as described in Sector Mounting

1. Align one of the holes on the extension bracket with the hole on the hanger mount.

See Figure 24

Figure 24. Align the extension bracket hole with the hanger mount hole