Installation guide

38
Installing the 7782 Access Point in the Field
Mounting the Access Point
Figure 19. Attaching the hanger mount to a vertical pole
4. Using a 10mm flathead screwdriver, tighten the clamp locks to secure the hanger mount
to the pole. Screw torque value must be 1.1-1.2 N.m or 9.7-10.6 in-lbs.
5. If required, then thread the safety cable around the hanger mount and thread the eye
end through the loop end.
Figure 20. Looping the optional safety cable around the hanger mount
Continue with “
Assembling the Mounting Bracket and the AP” on page 39.
NOTE: Hanger mount shown attached
horizontally to allow AP azimuth
adjustments. Attach the hanger mount
vertically to allow AP elevation
adjustments.
Eye
End
Hanger
Mount
Safety
Cable