Installation guide

37
Installing the 7782 Access Point in the Field
Mounting the Access Point
3. Remove the hanger mount or template from the mounting surface.
4. Follow the instructions in the customer-supplied wall anchor kit to attach the hanger
mount to the flat surface.
5. If required, then thread the safety cable around the hanger mount and thread the eye
end through the loop end.
Figure 18. Looping the optional safety cable around the hanger mount
Continue with “
Assembling the Mounting Bracket and the AP” on page 39.
Attaching the Hanger Mount to a Pole
The hanger mount can be attached vertically or horizontally on a 30mm to 60mm (1.18"
to 2.36
") pole.
NOTE: Figure 19 shows the hanger mount attached horizontally, which allows AP azimuth
adjustments. To allow AP elevation adjustments, rotate the hanger mount 90
º and install
vertically on the pole.
1. Insert the open end of one steel clamp into the upper two tabs on the hanger mount.
2. Take the other steel clamp and insert it into the lower two tabs on the hanger mount.
3. Use the clamps to attach the hanger mount to the pole (see Figure 19
).
Eye
End
Hanger
Mount
Safety
Cable