Installation guide

Installing the 7782 Access Point in the Field

Deploying the Access Point

In this section, you will mount the AP in its final mounting location. Perform the following:

■ Connecting and Sealing the RJ-45 Cable

■ Connecting the AP to the Network

Connecting and Sealing the RJ-45 Cable

The AP comes with two sets of RJ-45 waterproof connectors. To complete this step, you

will need one RJ-45 cable (two if you plan to use both the PoE IN and PoE OUT ports)

and the RJ-45 waterproof connector assembly.

1. Take out one of the two plastic bags containing the RJ-45 waterproof connector

assembly.

2. Feed the end of the RJ-45 cable through the sealing nut, rubber O-ring, and clamping

ring assembly as shown in Figure 17

Figure 17. RJ-45 waterproof connector assembly (P/N 902-0183-0000)

3. Connect the RJ-45 cable to the PoE IN port on the AP.

4. Wrap the clamping ring assembly around the rubber O-ring. Make sure that the

clamping ring assembly fully encloses the rubber O-ring.

5. Seat the clamping ring assembly and rubber O-ring in the cable gland base.

6. Hand-tighten the sealing nut.

7. If you are using both the PoE IN and PoE OUT ports, then assemble the second

waterproof connector by repeating Step 1 through Step 6.

Continue with Mounting the Access Point

Sealing nut

Rubber O-ring

Clamping ring assembly