Installation guide

31
Preparing the 7782 Access Point at the Depot and Shipping to the Field
Verifying AP Operation
Disconnecting the AP from the Power Source and the
Network
1. Disconnect the AP from the power source (either from the PoE injector or AC power
source).
2. Verify that the POWER LED is off.
3. Disconnect the Ethernet cable that runs to the AP’s PoE IN RJ45 port from your
network’s router or switch.
Continue with Disconnecting the AP from the Administrative Computer.
Disconnecting the AP from the Administrative Computer
1. If not already done, disconnect the AP from the power source (either from the AC
power source or PoE injector).
2. Verify that the POWER LED is off.
3. Disconnect the Ethernet cable from the administrative computer’s Ethernet port.
Continue with Restoring the Administrative Computer’s Network Settings
.
Restoring the Administrative Computer’s Network
Settings
If the administrative computer’s network settings were changed as described in “Config-
uring the Administrative Computer” on page 20 and you do not want to change the
network settings back now, then continue with “
Shipping the AP to the Field” on page 32.
If you do want to change the network settings back now, continue with the following steps:
NOTE: You may need to enable the firewall between the AP and the FlexMaster server
to complete this procedure.
1. On your Windows 7 or Windows XP computer, open the Network Connections (or
Network and Dial-up Connections) control panel according to how the Start menu is
set up:
• On Windows 7, click Start > Control Panel > Network and Internet > Network
and Sharing Center > Change Adapter Settings.
• On Windows XP, click Start > Control Panel > Network Connections.
2. When the Network Connections window appears, right-click the icon for Local Area
Connection, and then click Properties.
3. When the Local Area Connection Properties dialog box appears, select Internet
Protocol (TCP/IP) from the scrolling list, and then click Properties. The TCP/IP
Properties dialog box appears.