Installation guide

30
Preparing the 7782 Access Point at the Depot and Shipping to the Field
Verifying AP Operation
6. Connect the Ethernet cable from the Data In port on the PoE injector to your network’s
router or switch.
Continue with Associating a Wireless Client with the AP.
Associating a Wireless Client with the AP
1. In the client device's wireless interface, select the SSID configured in the “Configuring
Wireless # Settings” on page 26 section.
2. Connect the client device to the selected WLAN SSID.
After the wireless client successfully connects to the wireless LAN, continue with “
Checking
the TR069 Status (FlexMaster Management Only)” on page 30 or “Disconnecting the AP
from the Power Source and the Network” on page 31.
Checking the TR069 Status (FlexMaster Management
Only)
If you configured the AP to report to a FlexMaster server on the network (“(Optional)
Setting the FlexMaster Server Address” on page 27), then make sure you verify that the
AP can successfully communicate with the FlexMaster server. You can do this by checking
the TR069 status on the AP’s web interface.
1. In the AP’s web interface, go to the Administration > Management page.
2. Scroll down to the TR069 Status section.
3. Check the value for Last successful contact. If it shows a date in green, then the AP
was able to communicate successfully with FlexMaster.
Continue with Disconnecting the AP from the Power Source and the Network
.