Installation guide

25
Preparing the 7782 Access Point at the Depot and Shipping to the Field
Configuring the AP for Management by FlexMaster or for Standalone Operation
2. Verify that the common wireless settings are configured as listed in Table 5 .
3. If you made any changes to the Common tab, then click Update Settings.
4. Repeat Step 1
through Step 3 for Configuration > Radio 5G.
Continue with Configuring Wireless # Settings
.
Table 5. Common wireless configuration
Setting Recommended Value
Wireless Mode
• 2.4GHz (802.11b/g/n) for Configuration > Radio 2.4G > Common.
• 5GHz (802.11a/n) for Configuration > Radio 5G > Common.
Channel SmartSelect.
Channel Width 20MHz.
Country Code
• If you purchased the AP in the United States of America, then this
value is fixed to United States at the factory and is not user
configurable.
• If you purchased the AP outside the United States of America, verify
that the value is set to your country or region. Selecting the correct
country code ensures that the AP uses only the radio channels
allowed in your country or region.
NOTE: The two radios on the ZoneFlex 7782 AP are always configured
with the same country code setting. If you change the country code for
Radio 2.4G, for example, the same change will be automatically
applied to Radio 5G.
External Antenna
(7782-E only)
Always Enabled for 7782-E.
External Antenna
Antennas
(7782-E only)
• 2-antennas when only two external antennas are used for this band.
• 3-antennas when three external antennas are used for this band.