Installation guide

21
Preparing the 7782 Access Point at the Depot and Shipping to the Field
Configuring the AP for Management by FlexMaster or for Standalone Operation
4. Write down all of the currently active network settings. You will need this information
later when you restore your computer to its current network configuration.
5. Click Use the following IP address, and then configure the IP address settings with
the values listed in Table 3
. For a sample configuration, refer to Figure 12.
Figure 12. Sample configuration in the Internet Protocol (TCP/IP) Properties dialog box
6. Click OK to save your changes and close the TCP/IP Properties dialog box.
7. Click OK again to close the Local Area Connection Properties dialog box.
Windows saves the IP address settings that you have configured. Continue with
Connecting the AP to the Administrative Computer
.
Table 3. Configure your computer’s IP address settings
IP address 192.168.0.22 (or any address in the 192.168.0.x network—with the
exception of 192.168.0.1, which is the default IP address assigned to
the Access Point)
Subnet mask 255.255.255.0
Note: You can leave the Default Gateway and DNS server fields blank.