Installation guide

7
Planning the 7782 Access Point Installation
AP Connectors and LEDs
AP Connectors and LEDs
Figure 7 identifies the connectors and LEDs on all 7782 APs. Table 2 describes these
connectors and LEDs.
NOTE: 7782-E External Antenna APs also have seven extra N-type connectors on the top
cover. “
About the 7782-E Access Points” on page 47 describes these extra connectors and
their functions.
Figure 7. Connectors and LEDs on all APs - bottom view
PoE IN
PoE OUT
AC IN
Earth Ground
Screw
STATUS LED
POWER LED
Reset Button
(inside case)
Table 2. LEDs and connectors on all APs
Label Description
PoE IN RJ45 data
connector
Supports 10/100/1000Mbps connections, connects to the network and
receives 802.3at Power over Ethernet (PoE) from the Ruckus Wireless
60W PoE injector. (Refer to “
Appendix A: Ruckus Wireless-Supplied
and Customer-Ordered Parts” on page 65 to order a Ruckus Wireless
60W PoE injector.)