User guide

Managing the Access Point

Viewing Current Wireless Settings

If you want to view the current common wireless settings that the AP is using, go to

the Status > Wireless page (on dual band APs, go to Status > Radio 2.4G or Status

> Radio 5G). Ta b le 2 3

lists the descriptions of each common wireless setting.

If you want to make changes to any of these settings, go to the Configuration >

Wireless page. Refer to “Configuring Common Wireless Settings”

on page 46 for

more information.

Table 23. Common Wireless settings

Setting Description

Wireless Mode Shows the wireless mode that the AP is currently using.

Possible values include:

• Auto-Select

• 2.4GHz 54 Mbps

• 2.4GHz 11 Mbps

• 11ng (Operates with 802.11n, 802.11g and 802.11b

devices in 2.4GHz spectrum only)

• 11na (Operates with 802.11n and 802.11a devices in

5GHz spectrum only)

Channel Shows the wireless channel that the AP is currently using.

If you set the wireless channel to SmartSelect, this field

will show the value Channel # [SmartSelect].

Channel Width 11n devices only. Displays whether the channel width is

set to 20MHz or 40MHz.

Country Code Shows the country code that the AP has been set to use.

CAUTION: Verify that the AP is using the correct country

code to make sure it uses only the allowed radio channels

in your region. Selecting the incorrect country code may

result in violation of application laws.

AeroScout RFID tag

detection

Shows Enabled if you enabled AeroScout RFID tag

detection. The default setting is Disabled.

AeroScout Engine

communication daemon

Shows Up if the communication agent on the AP is able

to relay location data from AeroScout Tags to the

AeroScout Engine.

If the communication agent is unable to relay data or

AeroScout tag detection is disabled, this field will show

Down.