User guide

48
Configuring the Access Point
Configuring Wireless Settings
CAUTION: Selecting the incorrect country or region may result in violation of appli-
cable laws. If you purchased the Access Point in the United States, you do not need
to set the country code manually. Ruckus Wireless devices that are sold in the US are
preconfigured with the correct country code and this setting is non-configurable.
3. If you are using AeroScout Tags in your organization to locate assets or personnel,
you can use your ZoneFlex AP to relay location or presence data from the
AeroScout Tags to the AeroScout Engine via Wi-Fi.
To enable the AP to relay AeroScout data, click the Enabled option in AeroScout-
RFID tag detection.
To check the status of the AeroScout communication agent (which relays location
data from AeroScout Tags to the AeroScout Engine), go to the Status > Wireless
page. Refer to “Viewing Current Wireless Settings”
on page 81 for more informa-
tion.
NOTE: For other AeroScout-related configuration, refer to the AeroScout documen-
tation that was shipped with your AeroScout Tag and AeroScout Engine.
NOTE: If ZoneDirector exists on the network, you can enable AeroScout RFID tag
detection on all its managed APs at once. Refer to the ZoneDirector online help for
more information.
4. Click Update Settings to save your settings.
Country Code This option (if enabled) lets you select your
country or region code.
Advanced Settings Refer to “Reviewing Common Advanced
Settings” on page 49.
AeroScout RFID Select Enabled to enable AeroScout RFID tag
detection.
External Antenna NOTE: This option only appears if you are using
the ZoneFlex 2942 AP.
The ZoneFlex 2942 AP provides an external
antenna port, in case you want to attach an
external antenna to extend the range of your
wireless network. To enable the AP to use the
external antenna, select the Enabled option in
this section. This option is disabled by default.