User guide

Connecting an Administrative Computer to a Standalone AP

NOTE: Make sure that you configure the Local Area Connection properties, not the

Wireless Network Connection properties.

3. When the Local Area Connection Properties dialog box appears, select Internet

Protocol (TCP/IP) from the scrolling list, and then click Properties. The Internet

Protocol (TCP/IP) Properties dialog box appears.

4. Write down all of the currently active network settings. You will need this informa-

tion later when you restore your computer to its current network configuration.

5. Click Use the following IP address, and then configure the IP address settings

with the values listed in Table 12

. For a sample configuration, refer to Figure 15.

You can leave the Alternate DNS server box blank.

Figure 15. Sample configuration in the Internet Protocol (TCP/IP) Properties

dialog box

Table 12. Configure your computer’s IP address settings

IP address 192.168.0.22 (or any address in the 192.168.0.x

network – with the exception of 192.168.0.1, which

is already used by the AP)

Subnet mask 255.255.255.0

Default gateway 192.168.0.1

Preferred DNS server 192.168.0.1