User guide

23
Introducing the ZoneFlex Access Point
Getting to Know the Access Point Features
Table 10. Connector-side parts and connectors on the CMAP
Label Description
Ethernet Port RJ45 port that supports 10/100Mbps connections and provides
Power over Ethernet (PoE) power to compliant devices.
Antenna
Connector
One of the three connectors for the three 5GHz antennas supplied
with the CMAP. The other two connectors are located on the other
side of the unit (see Figure 14
).
DC Connector In addition to the power supplied by the coaxial cable from the
CMTS, the CMAP may also be DC powered.
Shorting pins 3 and 4 in the DC power connector using an electrical
shunt will reset the CMAP to factory default settings.
Coaxial Cable
Connector A
Provides a +/-3dB sample of the downstream RF signal as seen by
the cable modem. Refer to the ZoneFlex 7761CM Dual Band
802.11n Outdoor Access Point with Integrated Cable Modem
Installation Guide for more information on the CMAP signal levels.
Coaxial Cable
Connector B
Connects to the cable modem termination system (CMTS) at the
headend using a tap on the plant and it provides AC power to the
CMAP. AC power is supplied via Power Over Cable (POC).