User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
52
Resetting the Access Point to Factory Default Settings
Step 2: Attach the Dynamic Bracket to the Access Point
CAUTION: If you are not connecting 5GHz external antennas to the standard N-type
antenna interfaces on the Access Point, make sure that the metal caps remain installed
and securely fastened to protect the interface from elements, such as water and dirt.
You have completed connecting external antennas to the Access Point.
10 Resetting the Access Point to Factory
Default Settings
You can reset the Access Point to its factory default settings by shorting pins 3 and 4 on
the DC connector. Use the electrical shunt that is provided with the Access Point package
to perform this procedure.
NOTE: The Access Point can only be reset to factory default if it is using PoE.
1. Verify that the Access Point is using PoE as its power source.
2. Take out the electrical shunt that is supplied with the Access Point.
3. If the DC connector on the Access Point is protected by its cap, remove the cap. Take
note of the location of pins 3 and 4 (see Figure 41
).