User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
48
Mounting the Access Point
Step 2: Attach the Dynamic Bracket to the Access Point
Step 2: Attach the Dynamic Bracket to the Access
Point
1. Place the dynamic bracket onto the flat side of the Access Point so that the four screw
holes on the bracket align with the four screw holes on the Access Point. Make sure
that the shorter end of the mounting bracket is on the same side as the antenna
connector.
2. Insert four machine screws (supplied with the Access Point) into the screw holes on the
bracket.
3. Using a 6mm Phillips screwdriver, tighten the four machine screws to fasten the bracket
to the Access Point. Screw torque value must be 0.4-0.5 Newton meter (Nm).
4. Continue to “Mounting the Access Point”
in the next section.
8 Mounting the Access Point
To mount the Access Point, you will need to join the two mounting brackets that you
attached earlier to the device and the mounting surface. For this procedure, you will need
the following items:
■ Hex bolts
■ 10mm ratchet wrench