User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
47
Attaching the Mounting Brackets
Step 1: Attach the Static Bracket to the Mounting Surface
4. Using a 10mm flathead screwdriver, tighten the clamp locks to secure the bracket to
the pole. Screw torque value must be 1.1-1.2 Newton meter (Nm).
Figure 38. Tighten the clamp locks to secure the bracket
5. Continue to “Step 2: Attach the Dynamic Bracket to the Access Point”.