User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
44
Attaching the Mounting Brackets
Step 1: Attach the Static Bracket to the Mounting Surface
3. Remove the static bracket from the mounting surface.
4. Drill an 8mm-diameter hole with a depth of 36mm-38mm into each of the four markings
that you made on the mounting surface.
5. Insert a wall anchor (with the unthreaded part first) into each of the holes that you
drilled.
6. Place a metal cone on each wall anchor.
7. Align the four screw holes on the bracket with the wall anchors that you inserted earlier.
8. Use four flat washers and four hex nuts to attach the bracket to the mounting surface.
Figure 35. Insert a wall anchor into each hole that you drilled, align the holes on the
bracket with the wall anchors, and the secure the bracket with the flat
washers and the hex nuts
9. Using a 10mm open-end wrench, tighten the nuts to secure the bracket to the
mounting surface. Screw torque value must be 0.4-0.5 Newton meter (Nm). As you
tighten the nuts, the metal cones that are built into the wall anchors will expand and
lock the wall anchors into place.
10. Continue to “Step 2: Attach the Dynamic Bracket to the Access Point”
.
Wall anchor
Metal cone
Flat washer
Hex nut