User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
37
Deploying the Access Point
Step 2: Complete the Power Connections
For instructions on completing the power connection that you need to make, refer to the
procedures below:
■ Use Power Over Ethernet
■ Use DC Power
Use Power Over Ethernet
1. Take out the PoE injector and the power adapter from the Access Point package.
2. Obtain one outdoor-rated Ethernet cable and one indoor-rated cable.
3. Connect one end of the outdoor-rated Ethernet cable to the PoE IN port on the Access
Point, and then connect the other end to the AP/BRIDGE port on the PoE injector.
4. Connect one end of the other Ethernet cable to the NETWORK port on the PoE
injector, and then connect the other end to your network.
5. Connect the power jack to the DC48V IN connector on the PoE injector.
WARNING: Do not apply power to the Access Point at this point. You should connect the
Access Point to a power source only after you finish connecting all other components in
“Step 3: Connect the Access Point to the Network”
on page 41.
Figure 28. Connect the Ethernet cables and power adapter to the PoE injector
You have completed setting up the PoE power connection.
To Acce ss
Point
To network
To A C po w e r s o u r ce