User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
36
Deploying the Access Point
Step 2: Complete the Power Connections
Figure 27. RJ-45 waterproof connector assembly
3. Connect the RJ-45 cable to the PoE IN port on the AP.
4. Screw the clamping ring assembly onto the RJ-45 connector.
5. Push the rubber-O ring into the clamping ring assembly. Make sure that the clamping
ring assembly fully encloses the rubber-O ring.
6. Push the sealing nut forward and tighten it to seal the assembly.
If you are using both the PoE IN and PoE OUT ports, assemble the second waterproof
connector by repeating the same procedure.
You have completed connecting the RJ-45 cable and sealing the connection.
Step 2: Complete the Power Connections
The Access Point supports both PoE and DC power and it can be connected to both power
sources at the same time. If you want use both power sources, complete the power
connections in this step.
NOTE: If you want to use PoE only or DC power only (not both), you do not need to
complete this step. You already configured one power connection earlier when you
completed “Step 2: Connect the Access Point to the Administrative Computer” on
page 22
. You may continue directly to “Step 3: Connect the Access Point to the Network”
on page 41.
Sealing nut
Rubber-O ring
Clamping ring assembly
RJ-45 connector (PoE IN/PoE OUT port on the AP)