User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
32
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
Figure 26. Select the Use custom PoE injector check box
In addition to the supplied Ruckus Wireless PoE injector for ZoneFlex 7762 AP, you can
also use DC power or a standard 802.3af/802.3at PoE injector to supply power to the AP.
Note, however, that some features (specifically, the built-in heater and PoE for the PoE
OUT port) will be unavailable if the supplied PoE injector is not used. Refer to Ta ble 5
for
the available power options and the limitations associated with each option.
NOTE: If the built-in heater is disabled, the lowest operating temperature that the Access
Point can support is -20° C.
Table 5. Power configuration options
Power Input Operational AP Heater PoE for PoE OUT
Ruckus Wireless PoE injector
for ZoneFlex 7762 AP (with
supplied power adapter)
Yes Yes Yes
48V 802.3at Yes Yes No
48V 802.3at Yes Yes Class of power
supplied with
restrictions
48V 802.3af Yes No No
12V DC Yes No No