User guide

23
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
5. Connect the power jack to the DC 48V IN connector on the PoE injector, and then
plug the power adapter to a power source. The single LED on the PoE injector turns
green.
6. Check the Power LED on the side of the Access Point. Initially, the LED will turn amber
as the AP powers on. After it completes the power-on sequence, the LED will turn
green.
Figure 17. Connect the Ethernet cables and power adapter to the PoE injector
You have completed connecting the Access Point to the administrative computer and to
a PoE power source.
Use DC Power
NOTE: If you already assembled the DC cord connector in “Step 1: Connect the Cables
to the Access Point” on page 15, you only need to connect the DC cord connector to the
12V DC port on the AP (see Step 10 and onwards).
To use DC to power the Access Point, you need to assemble the DC cord connector, and
then plug it into the 12V DC connector on the AP. To complete this task, you will need:
■ A 0.195” to 0.265” diameter DC cable. Make sure that it is long enough to connect the
AP (at its mounting location) with the DC power source.
■ A pair of long nose pliers
■ A soldering gun (optional)
To assemble the DC cord connector and supply DC power to the AP
1. Connect one end of an Ethernet cable to the PoE IN port on the AP, and then connect
the other end to the administrative computer’s Ethernet port.
To AP
To admin
computer
To A C po w e r s o u r ce