User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
18
Configuring the Access Point
Configuring for Management by ZoneDirector
Figure 14. Pinout connections for the DC cable
Figure 15. Insert the conductors into the pins, crimp or solder the edges, and then
insert the pins into the connector
6. Push the coupling ring all the way forward so that it covers the edge of the cord
connector.
7. Push the cable clamp housing forward until it locks into the connector body. The two
clamps should snap into their compartments.
8. Push the boot all the way forward so that it covers the cable clamp housing securely.
9. Remove the protective cap from the 12V DC connector on the AP.
10. Connect the DC cord connector that you have assembled to the 12V DC connector on
the AP.
11. Connect the DC cable to a DC power source (for example, a battery).
You have completed connecting the Access Point to a DC power source.
No. Pinout
1+DC power
2-DC power
3Factory reset
4Ground
1
4
2
3
Crimp or solder the conductors
before inserting them into the
connector