User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
17
Configuring the Access Point
Configuring for Management by ZoneDirector
Figure 12. DC cable connector assembly
3. Strip the DC cable for about 3/8” and each of the four conductors for about 7/32”.
Figure 13. Strip the DC cable and the four conductors
4. Insert the stripped part of the conductors into the four connector pins, and then crimp
the edges of the connector pins to secure the conductors. Alternatively, use a soldering
gun to solder the conductors to the pins.
5. Insert all four connector pins into the holes on the cord connector. See Figure 14 for
the correct pinout connections.
Cable clamp
housing
Boot
Coupling ringDC cable
3/8 inches (max)
7/32 inches (max)