User guide
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Verifying Access Point Operation
- 6 Deploying the Access Point
- 7 Attaching the Mounting Brackets
- 8 Mounting the Access Point
- 9 (Optional) Mounting and Connecting the 5GHz External Antennas
- 10 Resetting the Access Point to Factory Default Settings
- 11 What to Do Next
16
Configuring the Access Point
Configuring for Management by ZoneDirector
4. Connect one end of the other Ethernet cable to the NETWORK port on the PoE
injector, and then connect the other end to ZoneDirector directly or through a hub.
5. Connect the power jack to the DC 48V IN connector on the PoE injector, and then
plug the power adapter to a power source. The single LED on the PoE injector turns
green.
6. Check the Power LED on the side of the Access Point. Initially, the LED will turn red as
the AP powers on. After it completes the power-on sequence, the LED will turn green.
Figure 11. Connect the Ethernet cables and power adapter to the PoE injector
You have completed connecting the Access Point to the network and to a PoE power
source.
Use DC Power
To use DC to power the Access Point, you need to assemble the DC cord connector, and
then plug it into the 12V DC connector on the AP. To complete this task, you will need:
■ A 0.195” to 0.265” diameter DC cable that is long enough to connect the AP (at its
mounting location) with the DC power source.
■ A pair of long nose pliers
■ A soldering gun (optional)
To assemble the DC cord connector and supply DC power to the AP
1. Take the small plastic bag containing the DC connector pins and DC cord connector
from the AP package. Take its contents out.
2. Feed the end of the DC cable through the boot, cable clamp housing, and coupling
ring (in the same order). See Figure 12
.
To AP
To network
To A C po w e r s o u r ce