User guide

56
Managing the Multimedia Wi-Fi Wall Switch
Configuring Management Access Options
2. Review the access options listed in Table 20 , and then make changes as needed.
3. If you want the Multimedia Wi-Fi Wall Switch to be accessible for management
from outside of the local network, select the Allow Remote Management check
box.
4. If you want to allow specific IP addresses only to be able to access the device for
remote management, select the Limited by IP Range check box, and then specify
the IP addresses or IP address ranges that are allowed to access the device by
entering the IP address and network mask combination. You can specify up to four
sets of IP address ranges.
5. Click Update Settings.
You have completed configuring the options for management access.
Table 20. Management Access Options
Option Description
Telnet access By default, this option is disabled (inactive).
Telnet port This field lists the default Telnet port of 23. You can manually
change this port number, if required.
SSH access By default, this option is enabled (active).
SSH port This field lists the default SSH port of 22. You can manually
change this port number if required.
HTTP access This option is enabled by default.
HTTP port This field lists the default HTTP port of 80. You can manually
change this port number if required.
HTTPS access By default this option is enabled. This connection mode
requires a security certificate, a copy of which has been pre-
installed in the device.
HTTPS port This field lists the default HTTPS port of 443. You can
manually change this port number if required.
Certification
Verification
This notes whether the security certificate linked to the
HTTPS settings has been passed or not.
Auto Provisioning? Enabled by default. Auto Provisioning allows configuration
of multiple ZoneFlex 7025s at once.