User guide

Configuring the Multimedia Wi-Fi Wall Switch

Configuring LAN Ports

• Address: Six text boxes appear in which you enter the desired MAC address,

in hexadecimal digit form, two characters in each box. You can specify a full

12-hex-digit MAC address or enter “wildcard” characters for “don't care”

digits. Allowable hex-digit characters are 0-9, a-f, and A-F. Most address-tags

and software where you find MAC addresses listed include colons or dashes

to separate the address-pairs; that is provided for you on the web page, so do

not enter the colons or dashes.

Supported wildcard characters include “x”, “X” and blank (space character).

Wildcards are useful when you want to specify all MAC addresses from a given

manufacturer. For example, by specifying only the Organizationally Unique

Identifier (the first six hexadecimal digits of any MAC address from that

manufacturer is its OUI) saves you having to enter all 24 million of them (the

table size is limited in the AP/Router to 128 entries). Some manufacturers

produce devices using more than one OUI, in which case you may need to

enter each applicable one.

7. Click Update to save your changes. Assuming all parameters you entered are

acceptable, that row will be added to the table.

You have completed adding an entry to the MAC address table. If you have additional

MAC addresses you want included, click Add new entry, and then repeat these steps

until you have entered all the stations you want. There is a limit of 128 rows.

Removing a MAC Address

To remove a MAC address from the ACL table, click the Cancel button under the

Remove column, and then click Update. The ACL table refreshes, and the MAC

address that you deleted disappears from the table.

Configuring LAN Ports

Each of the four LAN ports on the bottom of the AP can be configured independently,

allowing you to disable one or more ports or assign a VLAN ID to each port.

By default, the LAN1-LAN4 ports are enabled Access Ports with no VLAN assigned.

The LAN5/Uplink port on the rear of the ZF7025 is a trunk port and is not configurable.

LAN4 also provides PoE out to provide power to PoE-capable devices such as IP

phones. Additionally, the ZF7025 includes a pass through port on the side. The pass

through port is not configurable.