User guide

43
Configuring the Multimedia Wi-Fi Wall Switch
Setting Threshold Options
• RADIUS NAS-ID: Enter the network ID assigned to your RADIUS server.
• Authentication Server [-Required-]: Enter the information needed to estab-
lish a connection between the Multimedia Wi-Fi Wall Switch and the RADIUS
server.
• Accounting Server [-Optional-]: Enter the information needed to establish
this connection.
6. Click Update Settings to save and apply the changes. A confirmation message
appears at the top of this page.
7. Click Go back to Wireless Configuration to reopen the previous page.
Setting Threshold Options
The following options allow you to fine-tune the “Protection Mode” behavior, set
previously on the Configuration :: Wireless :: Advanced :: Common page. After
activating a Protection Mode, you can open each Wireless tab and customize the
threshold settings, which determine what is put into effect and when.
CAUTION: Do not customize these options unless you are an experienced network
administrator or are under the guidance of an IT/support professional.
To customize Protection Mode (Threshold) settings
1. Go to Configuration > Wireless. The Configuration :: Wireless :: Common page
appears.
2. Click the tab for the Wireless # (WLAN) that you want to configure. The Configu-
ration :: Wireless :: Wireless [#] page appears.
3. Look for Threshold Settings, and then click Edit Settings. The Configuration ::
Wireless :: Advanced :: Wireless [#] page appears.