User guide

32
Configuring the Multimedia Wi-Fi Wall Switch
Configuring Wireless Settings
To configure the wireless settings common to all WLANs
1. Go to Configuration > Wireless. The Configuration :: Wireless :: Common page
appears.
2. Make changes to the common wireless settings listed in the table below.
CAUTION: Selecting the incorrect country or region may result in violation of appli-
cable laws. If you purchased the Multimedia Wi-Fi Wall Switch in the United States,
you do not need to set the country code manually. Ruckus Wireless devices that are
sold in the US are preconfigured with the correct country code and this setting is non-
configurable.
Table 12. Common Wireless settings
Setting Description
Wireless Mode Only one wireless mode is available on the
ZF7025:
• 2.4GHz (802.11b/g/n): This setting allows
802.11b, 802.11g, and 802.11n compliant
devices to join the network on the 2.4GHz
unlicensed band.
Channel This option lets you select the channel used by the
network. You can choose SmartSelect, or choose
one of a specific number of channels. If you
choose SmartSelect, the AP automatically selects
the best channel (encountering the least
interference) to transmit the signal.
Channel Width Set Channel Width to 40Mhz or 20Mhz (default).
The 802.11n standard allows the use of 40MHz
channel width, which allows higher transmission
speeds. Setting the channel width to 20MHz will
result in lower transmission speeds, but can allow
for more wireless devices to be deployed in
proximity without overlapping channels.
Country Code This option (if enabled) lets you select your
country or region code.
Advanced Settings Refer to “
Reviewing Common Advanced
Settings” on page 33.
AeroScout RFID Select Enabled to enable AeroScout RFID tag
detection.