User guide

19
Installing the Multimedia Wi-Fi Wall Switch
Physical Installation
• If required, connect the cable providing support for pass-through devices to
the Pass Through port.
3. Mount the ZoneFlex 7025.
• Align the mounting bracket with the outlet box so that the two screw holes
line up, and pull the Ethernet cable through the center of the mounting
bracket.
• Affix the mounting bracket to the outlet box using the two mounting screws
provided.
• Snap the AP onto the mounting bracket by hooking the two locking tabs on
one side of the mounting bracket into the two cutouts in the plastic housing
on one side of the AP, then push the other side of the AP in toward the wall
until it snaps in place.
Figure 12. Hook the locking tabs into the housing cutouts
You have completed the physical installation.
Using the 110 Punch down Block
CAUTION: Do not connect both the Punch-down block and the Uplink port to a
network. Only one connection can be used at a time.
If you prefer to use the 110 Punch-down block connector rather than the RJ-45
connector for power and network connectivity, refer to the following diagram for
wiring details.
Cutouts
Locking
Tab s