User guide

4
Before You Begin
Prepare the Required Hardware and Tools
Figure 2. Mounting kit contents
3 Before You Begin
Before installing and setting up the Access Point, Ruckus Wireless recommends that you
first complete the following pre-installation tasks.
Prepare the Required Hardware and Tools
You must supply the following tools and equipment:
■ A notebook computer running on Windows XP/2000 and installed with one wireless
802.11b/g network card and one Ethernet card
■ 6mm flathead screwdriver
■ 6mm Phillips screwdriver
■ 10mm ratchet wrench
■ 3mm Phillips screwdriver (if you will be using DC power)
■ Electric drill with 8mm drill bit (if mounting on a flat surface)
Bottom cover DC terminal block Black solid rubber
stopper (2 pieces)
Rubber O-ring (1
black and 1 green)
White P-clip cable
clamp
Machine screw (2
pieces)
Machine screw with
washer (3 pieces)