User guide

Mounting the Access Point

Step 2: Attach the Dynamic Bracket to the Access Point

Figure 34. Joining the two brackets in a vertical pole installation

2. Align the mounting holes on the dynamic bracket with the mounting holes on the static

bracket.

3. Place a split lock washer, and then a flat washer onto a hex bolt. Then insert the hex

bolt into one of the mounting holes.

NOTE: Make sure the screw-washer assembly is in correct order. The split-lock washer

should be in the middle and the flat washer should touch the bracket.

4. Repeat Step 3 for each of the mounting holes. There are four mounting holes on the

bracket – two on each side.