User guide

24
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
Figure 14. Connect the ground wire to the V- terminal and the +12v DC wire to the V+
terminal
5. Using a 3mm Phillips screw, tighten the wiring terminal screws. Screw torque value must
be 4kg-5kg.
6. Connect the DC terminal block to the 12V DC port on the Access Point.
Figure 15. Connect the DC terminal block to the 12V DC port
7. Connect the DC cable to a DC power source (for example, a battery).
You have completed connecting the Access Point to the administrative computer and to
a DC power source.
Ground Wire to
V- Terminal
12V DC Wire to
V+ Terminal