User guide

Ruckus Wireless ZoneFlex 2925/2942 User Guide | After the Installation (Post-Installation Setup)
25
Customizing Common Wireless Configuration
To configure the wireless settings common to all hotspots, follow these three steps:
1 Open the Web User interface, and click Wireless under Configuration.
The Configure::Wireless::Common workspace appears.
FIGURE 3-7
2 Make changes to the following options (if necessary):
Wireless mode The wireless mode options include the following:
Auto-Select: Allows both 802.11g- and 802.11b-compliant devices to
connect to the network. This is the default set
-
ting.
2.4GHz 54 Mbps (For faster 802.11g devices only): Allows only
802.11g-compliant devices to join the network.
2.4GHz 11Mbps (For slower 802.11b devices only): Allows only
802.11b-compliant devices to join the network.
Channel This menu lets you select the channel used by the network. You can
choose SmartSelect, or choose one of a specific number of channels.
If you choose SmartSelect, the AP selects the best channel (encounter
-
ing the least interference) to transmit the signal.
Country Code This menu, if active, lets you pick your country or region code.
Advanced Settings See “Reviewing the Advanced::Common Options” on page 26.
ALERT
Do not undertake the customizing of these options unless you are an experienced network
administrator or are under the guidance of your ISP or an IT/support professional.