User guide

Ruckus Wireless ZoneFlex 2925/2942 User Guide | After the Installation (Post-Installation Setup)

2 Verify that the Connection Type is “Static IP”.

3 When the Static IP options appear, you can make the following changes:

Gateway This is the gateway IP address of the Internet interface.

Primary DNS Server This is the primary Domain Name System (DNS) server IP

address.

Secondary DNS Server This is the secondary Domain Name System (DNS) server IP

address.

4 Click Update Settings to save and apply the changes.

Changing the Connection Type

To change the connection type (DHCP, PPPoE or Static IP), follow these steps:

1 After logging into the Web User interface, click Internet under Configuration.

2 When the Configure::Internet options appear (as shown previously), click the button

by the Connection Type to be applied to this AP.

Typically, connection options relate to your ISP’s delivery method:

• in certain uncommon instances, a static IP address is provided

• for cable modem access, DHCP is used

• For DSL access, PPPoE is used

3 If you need to change to PPPoE or Static IP (from DHCP), fill in the related fields

according to your ISP-provided information.

4 Click Update Settings to save and apply the changes.

FIGURE 3-6

ALERT

Perform this task only with guidance from your ISP. The required entries for static IP or

PPPoE should be available, if your AP connection type is changed to either of those types.