User guide

Ruckus Wireless ZoneFlex 2925/2942 User Guide | Installation, Setup, and Placement of the AP
9
AIR
• If off
• If blinking red/amber alternately
• If blinking red/green alternately
• If flashing green
• If steady green
• There is no station associated.
• AP is booting up.
• Wireless data traffic is unreachable.
• Wireless data traffic is reachable.
• Good air quality.
WLAN
• If steady yellow
• If steady green
• No wireless client are associated.
• At least one wireless station is associated. Also steady green during
boot up.
10/100
POE
• If off
• If steady amber
• If flashing amber
• If steady green
• If flashing grren
• Port is not connected.
• Ethernet port is connected to 10Mbs Layer 2 device.
• Ethernet port is passing traffic to a 10Mbs Layer 2 device.Ethernet
port is connected to 100Mbs Layer 2 device.
• Ethernet port is passing traffic to a 100Mbs Layer 2 device.
10/100
• If off
• If steady amber
• If flashing amber
• If steady green
• If flashing grren
• Port is not connected.
• Ethernet port is connected to 10Mbs Layer 2 device.
• Ethernet port is passing traffic to a 10Mbs Layer 2 device.Ethernet
port is connected to 100Mbs Layer 2 device.
• Ethernet port is passing traffic to a 100Mbs Layer 2 device.
Table 1: ZF2942 Side and Rear LEDs
LED If you see this... This is happening...