User guide

72
Managing the Smart Wi-Fi Gateway
Upgrading the Firmware
Upgrading Manually via the Web
1. In the Upgrade Method options, click Web.
2. Click the Web Options URL field, and then type the URL of the download Web
site. Remember to start the URL with the http:// prefix.
3. You can change the Image Control File filename extension as noted here:
• Replace any file names ending in .rcks with the .html extension
• Replace any file names ending in .fI7 with the .html extension
CAUTION: Do not change the Username or Password entries.
4. Click Perform Upgrade. A status bar appears during the upgrade process.
5. After the upgrade is completed, you must manually reboot the Smart Wi-Fi
Gateway.
Upgrading Manually via FTP or TFTP
1. In the Upgrade Method options, click FTP or TFTP.
2. Click the host name field, and then type the URL of the server. Or click the IP
address field, and then type the IP address of the server.
CAUTION: Do not change any of the Image Control File, Username, or Password
entries.
3. Click Perform Upgrade. A status bar appears during the upgrade process.
4. After the upgrade is completed, you must manually reboot the Smart Wi-Fi
Gateway.
Upgrading from a Local Computer
1. Download the upgrade file to your local computer.
2. In the Upgrade Method options, click Local.
3. Under Local Options, click the Browse button, and then go to the location where
you saved the upgrade file.
4. Select the upgrade file, and then click Open.
5. Click Perform Upgrade. When the upgrade is completed successfully, a message
appears.