User guide

38
Configuring the Smart Wi-Fi Gateway
Configuring System Settings
To configure the system settings
1. Go to Configuration > System. The Configure :: System page appears.
NOTE: Take note of the Bridge and Route options under the first column. You will
select one of these two options for each of the interfaces on the Smart Wi-Fi Gateway
to set the operation mode.
2. Under the (Ethernet interface) icon, click either the Bridge and Route option
to set the operation mode for the Ethernet interface, which connects to your
service provider’s Wireless Broadband Network.
3. Under the (Wireless 1) icon, click either the Bridge and Route option to set
the operation mode for the first wireless interface, which connects wireless clients
to the Smart Wi-Fi Gateway.
4. Repeat Step 3 for the (Wireless 2) interface.
5. In Uplink WDS Mode, make sure that the Enabled option is selected (default) if
you want to enable WDS. Otherwise, click Disabled.
6. Click Update Settings to save your changes.